those trucks had common problem of the blower motor resistor going bad or burning out and it would only work on high speed. the resistor is located under the passenger side dash by the blower motor. hope this helps
This also happenned on my Liberty. It was not in the switch or in the fuse box, a part needed to be replaced by the dealership. Addendum: That might have been the fan speed resistor block that they replaced. Ninety-eight per cent chance that was the fan speed resistor. I bought one on eBay for $27 and replaced it in about 10 minutes. You need to drop the glove box by pushing in the holder clips. Inside you'll see a part with several wires held to the heater housing by two bolts. Remove the bolts, turn around the assembly, and there's your resistor, ready for replacment. Piece of cake.
You do not have to turn the heater on until you are ready to heat the water, some installers put a tee or bypass before the heater so the water does not go thru the heater many do not since the heater is on the clean side of the filter, some people just want a bypass valve their in case the heater fails they can keep the water flowing around the heater, Take the cover off, start the filter up, start vacuumimg, when ready add your chemicals. continue running the filter get your water tested, when you feel you are about ready too swim turn the heater on too warm the water if you desire to.
You do not have to turn the heater on until you are ready to heat the water, some installers put a tee or bypass before the heater so the water does not go thru the heater many do not since the heater is on the clean side of the filter, some people just want a bypass valve their in case the heater fails they can keep the water flowing around the heater, Take the cover off, start the filter up, start vacuumimg, when ready add your chemicals. continue running the filter get your water tested, when you feel you are about ready too swim turn the heater on too warm the water if you desire to.
Your blower motor is getting ready to fail, it is usually gradual. I have replaced 2 on my 200 Kia Sportage and in both cases the low sppeds failed first. This may also require the relay be replaced as when it finally fails it can take the relay out.
check your thermostat or your heater core may be getting ready to go out
It's not a light switch! It's not a light switch!
Im sure you have to pull the dash out and it should be right there in front of you in the passenger side seat. Just take a few bolts out after that holding a plastic cover on in front of it. I just replaced one on my 95 sure it should be the same. be ready for a job.
Most fish are around 78 degrees F.
The female guppy will be very large and will have a gravid spot near her anus. But when she is ready to give birth she will be very still and huddling near the heater in your tank.
you go to the ready screen and choose the bakugan u want
Go to the Ready Screen, then choose the Bakugan tab at the top.
Yes if it is done soon , and you have a person ready to donate an eye soon..