0
Why does your smoke detector still beep after you push the button to turn it off?
Wiki User
∙ 12y ago
The batteries are probably dead ! you should probably replace them and see if it stops! that could be dangerous :)
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Why does your smoke detector beep only at night?
Incase you are sleep and a fire starts the smoke detector will wake you up
Why do smoke detectors make a beeping noise when the electric goes off they are not hooked to any electric?
When the electricity goes out, a smoke detector may make a final beep as it's capacitor is discharged, as a warning. If the smoke detector has a battery backup, some detectors will beep just to let you know the power is off, and some other units will only beep when the power is off AND the battery is low. Usually there is a legend on the back of the unit that will tell you what the different beeps mean.
Will a short circuit cause smoke detectors to beep after resetting the circuit breaker?
If your smoke detector is bleeping you have a serious risk of fire and the circuit breaker must not be reset until the fault that caused it to trip is investigated.
What would make the detector still beep after the battery is changed?
Assuming this is a question about a smoke detector: 1.The sensor can be obscured with dirt and/or dust 2. An insect such as a spider may have be obscuring the sensor. Sometimes you will even find a web inside the detector. 3. The detector may be defective. 4. The battery, even though it has been changed, may provide too low a voltage to the device. Make sure the battery itself is OK.
Onomatopoeia for when a metal detector sound?
Beep Boop Cling Clang Screech Ding Really dood, just use your imagination!
What does one single loud beep coming from the smoke detector mean?
Hey there, I had this problem, do you live in a apartment block? If so, it is most likely connected to a main system, but the individual alarms still have 9v batteries in them to protect against power cuts, this battery is running low and needs replacing Or you can do what I did and just rip them off the ceiling in anger. Ta, Ensig_Prs
Why did the metal detector beep when there was nothing wrong?
If there was nothing wrong then it had correctly detected something
How do you turn off the beep on a Nixon lodown?
Hold the wave#/reset button till it beep
In binweevils how do you get in the pyramid?
Put the battery in the metal detector and then atatch the stick to the cranck click on it get the metal detector and look and wait for a beep and then dig it up with the spade
Why do some smoke alarms beep when the power goes out-?
Some smoke alarms beep when the power goes out because they are hardwired to the power system and resetting. Not all smoke alarms are hard wired to the building's electrical system.
Can you change a hard wired smoke detector with the electric on?
It is not a good idea to work on any electrical circuits with the voltage on. Depending on the year when your smoke detector was installed it might have a quick disconnect to change out the device without having to physically having to undo any wire connections. Earlier models had screw terminals that connected to the circuit. Turn the circuit breaker off that supplies the voltage to the smoke detectors. Copy on a piece of paper the wire colours that are on the specific terminals of the detector. Replace the wires on the same terminals on the new detector. Turn on the breaker, the smoke detector will beep and then go quiet, They are now monitoring your home again. Don't forget, when you have the power off, vacuum the other detectors to get rid of built up dust that can cause nuisance tripping.
How do you beep?
You shove the button in the center of the steering wheel.
