Because it is looking for the original remote, so it jams any signals that could distract it from its current task (finding original remote). Is there any way to "turn that off"?
More than likely the remote is a radio device and the control circuit of the energy saving lamp is emitting interference on the same frequency as the remote. The remote controller has an IR lamp similar to an LED lamp.
When i first bought the wii remote charger, it said to charge for 12 hours but i only ended up charging for twenty minutes. The battery life is now poor, what can i do
For a remote auto starter to work, a person must first press his/her keyless control. This sends a radio signal to the module located within the car. The module activates the ignition. After the ignition is activated, the car starts up without the person having to do it manually.
What kind of remote do you have.
Remote is in outlying areas and the first aid and skills are referred to wilderness first aid and survival. See related link.
Newfoundland is where the first signal was received.
what year was the remote control invented?
the first practical radio signal system is Jan Hendrix Campos
Check the batteries in the remote first
Replacing a turn signal bulb on a 2005 Chevy Cavalier can take less than a few minutes requiring no tools and just the bulb itself. First locate the housing the turn signal located in the trunk, then remove the plastic cover. Pull out the old bulb and install the new unit.
Replacing a front signal turn bulb on a 2000 Chevy cavalier takes all abut a few minutes to complete. First find the housing for the turn signal which is located in the engine compartment. Pull back the bulb from the light housing and remove it from the clip. Lastly install the new light.
The first.