Want this question answered?
NO must be 50amp
You can reset a circuit breaker but a fuse you must replace.
In the 1997 it is under the hood.On the left hand side of the fuse box . It is directly under a little silver piece. To reset door you must remove fuse (red 10 volt0 for 1 min then replace. In another minute your door will be reset. Also will need to reset your radio time.
Copper sulphate is a compound, so copper must be obtained through a chemical reaction. To obtain copper from copper sulfate, do the following: Place a piece of aluminum wire into a copper sulphate solution. Aluminum will replace the copper in the copper sulphate and copper will come out of solution and form along the aluminum wire, actually replacing the atoms of aluminum. The chemical equation is 2Al(s) + 3CuSO4(aq) ---> 3Cu(s) + Al2(SO4)3(aq). This kind of reaction is called a single replacement or single displacement.
Yes, a 250V fuse can replace a 125V fuse if they have the same ampacity rating. The voltage rating is simply the maximum voltage that the fuse is capable of safely interrupting. You can go higher, but you can not go lower. Obviously, the form factor of the fuse must be the same, but that is often the case.
The particle given off must be common in all elements.
All plugs, by law, must have a fuse. Unplug the wii and open up the plug with a screwdriver to get at the fuse if you think it has blown. Remember that if you replace it, make sure it is with a fuse of the same maximum voltage!
You do not replace the wire - you replace the fuse as a whole unit. Never try to "get by" with anything but the correct fuse - it is asking for a fire if you don't. If you have the old style which have screw on caps, you remove the caps and replace the fuse with the exact fuse material that is identical to the one that burned. Reinstall the caps tight and re-insert the fuse. These types of fuses are becoming obsolete and can be hard to find the fuse material for them. You can replace the fuse with a newer fuse rated for the same amperage as the old one. Note, however, that this type of fuse is higher amperage - 30 amps or above. The type of fuse described at the beginning of this answer - the old "screw in" type - is not fixable - it must be replaced outright
Sometimes we have to push the button several times.
Then the problem must be ahead (before) the headlamp (wiring, switch, fuse).
Mercury must be collected with a piece of copper dipped before in mercury to form an amalgam on the surface.
Mercury must be collected with a piece of copper dipped before in mercury to form an amalgam on the surface.