It doesn't need to be
Safety flame
no
The blue flame of the Bunsen burner is when it is hottest. The yellow flame is the safety flame. you should always start the burner on the safety flame which is produced when the holes on its base are closed.
when you light up the burner you should see that the Bunsen burners air hole is closed that is the safest flame
you put your water in the bursen burner then put in on heat the heat should be moderate to avoid vigorous boiling.Alway take note that you do not make the mouth of the bursen burner to face you put it the opposite side and do not lok in side the bursen burner.
WHO is teaching you to light Bunsen burners with matchsticks? That is so unsafe and wrong. You can get burned really easily like that, and Bunsen burner burns are always bad. Go to a hardware store and spend $5 on a spark lighter, like welders use to light their torches. Those are a safe way to light your burner.
If you light the burner from the top, the lighting instrument will be blowin out by the force of the gas.
After a tsunami or other natural disaster there may be broken gas lines. Lighting a match near one may cause and explosion.
there should be a knob on the bottom, make sure that it is loose, turn the top of the burner like you are unscrewing it, then turn the gas on, use a striker or fire starter to light it over the top, you should hear the gas moving through it before lighting it
Matchstick blinds are a good option. It really just depends on your preference, style, house setting, and look you are going for. I do think they would be good for your home.
You have to relight the Bunsen Burner every time you use it.
What Should You Do - 2003 Lighting Strikes was released on: USA: 2003
bunsun (burner) :P
A white light
Watch out for the fire as it might burn the equipment
If you are looking to replace the washer nozzle cover (the painted part) all you have to do is carefully pull out the nozzle with a pair of needle-nose pliers and hold onto it while installing the new plate. You should be able to let go of the nozzle after installed the new plate and it will retract itself into the bumper.
This is not a very well worded question. What do you mean by why should it be used? I Bunsen burner is used for heating things, usually in a lab setting.