answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Why when i start fan motor it starts backward and then when i stop and restart it runs?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Mazda B3000 will not restart when hot?

when it does not start disconect your cts (colant temperature sensor )and then start if it starts replace your cts


Can you start and stop a 20 hp motor several times a day?

The ability to start and stop a 20 hp motor, or any other large motor, several times a day depends on the motor. Look at the nameplate on the motor. It will tell you the criteria for restart, if applicable.


When is Iditarod?

The Iditarod always starts on the first Saturday in March, with a ceremonial start in Anchorage. The restart is the next day.


What is the firing order of a 1984 Dodge ES Sedan but does it start from the front of the motor or the rear of the motor?

It always starts from the front of the motor.


98 Metro starts and runs fine when cold When you have to restart when hot it will not start?

your car may need a new thermostat


When is the next Iditarod race scheduled?

The Iditarod always starts on the first Saturday in March, with a ceremonial start in Anchorage. The restart is the next day.


Why does your dodge ram 1500 start once a day but once it starts it wont restart again until the next morning?

gauges don t work truck wont start


Why would a 1992 ford ranger be running fine turn it off try to restart and will not start motor will turn over but will not fire?

ignition module


98 5.7 TA won't start Cranks fine Shot starter fluid down throttle body motor starts runs fine Go to restart and only cranks Have done this 3 times Don't want to hurt the motor with starter fluid?

could be fuel pump or a bad sensor - really needs to go to the dealer to be plugged into their computer


Why is hot start and cold start term used in 3 phase induction motors?

In a 3 phase induction motor, particularly the larger units, hot start and cold start refer to the temperature of the motor when starting. Hot start is usually a restart after coasting to a stop. Cold start is an initial start, after not having run for a relatively long period of time. This is important because there is usually a limit on the number of hot starts that are allowed in a certain period of time. This is due to the fact that these motors pull more current starting than when they run, and if you start them too often they can overheat.


Your 1989 Mercedes 300E is hard to start in the AM but once it starts it will restart normally during the entire day The next AM the same hard start Possible crank shaft sensor issue?

hi! cold start valve.


96tacoma 2wd starts runs great shut off and will start for 20 mins then runs great again any body know why restart within 5 mins then wont start?

snargal fluff