Want this question answered?
Because the two pipes are connected, and the shower is farther down the line than the toilet. So when you flush, you are hearing the water from the toilet pass by your tub. This is also why you will have sewage in your tub if your waste water line is extremely backed up.
Run a new cold supply line from the source. This will drain less pressure from the the cold shower line.
A down line clog would cause this. The shower drain is lower than any other drain in the bathroom so it is the first to tell you of a clog in the line. Time to Roto Rooter! Y-THINK-Y The toilet and shower must have the same drain. There is a blockage somewhere after the toilet and shower drains meet. The backup takes the easiest route back which must be the shower drain. Try snaking out both drains. Start with the toilet. To do the best job, remove the toilet and start from floor level.
This indicates that it has a toilet, sink and a shower but no bathtub. A 1.50 indicates that it has a toilet, sink but no shower or bathtub.
A bathroom would have a toilet-sink-tub and or shower. A half bath has a toilet maybe a sink but no tub or shower.
I can be but the toilet needs to have 24" in front of it to be legal. Plus you cannot tie your shower drain in the the horizontal branch of the toilet.
Because the Shower Hummed
you pee in the shower?
The drains for the shower, toilet and sink all connect to a common line. Assuming the toilet is not backing up, the problem indicates that there may be a partial blockage, enough so that some of the toilet flow is backing up through the shower drain line. You need plumbing repair. The shower leak you mention should only be in the shower, or else you have a broken drain line as well.
A shower drain is 1 1/2 or 2 inch and a toilet needs to be either 3 or 4 inch.
A full bath is a bathroom with a toilet and bathtub/shower. A half bath is either a bathroom with only a toilet, or a bathroom with only a bathtub/shower. A full bath doesn't require a bathtub and a shower.
Yes.