answersLogoWhite

0


Best Answer

I have had them fail due to heat. I used a certain dilectric grease on the underside to help dissipate the heat. If not heat, then possibly a poor ground.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why would the ignition coil module keep failing on a 1992 MAZDA 626?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

Where is the ignition module on a 1993 Ford Taurus located?

On the bottom side of the engine( front of the car) just below the exhause manifold. It is easiest to remove the mounting plate from the body of the engine, as balancing the coils on the module as you remove and insert screws if a real pain in the but. If anyone has any suggestions on waterproofing this area, I would greatly appreciate it, as I have gone through three of these modules in three years due to water getting into it and shorting the module out. This last time it was a coolant leak around a seal on the top of the water pump, spraying right into the module that caused it. Argh!


Why does a 1993 Ford F150 4x4 pickup stall out after it heats up?

It sounds as if you have a bad ignition control module. It would be located on the distributor. On some of these vehicles, the module was moved over on to the side of the left fender. Ford had a lawsuit against them for these modules, but the time to submit claims against them has expired. It is also referred to as the thick film ignition (TFI)module.


Would a bad ignition switch cause a car to crank but not turn over Car is 1994 Ford Mustang GT?

first check to see if your distributor is getting power to it and if it is check to see if the stator inside your distributor is sending a signal to the ignition module, just hook up a test light between the stator going to the ignition module to ground


What would make your van shut off while driving and won't start sometimesI put a new coil and distributor cap and rotor on it?

Ignition module is a possibility.


When car will not start with news battery what is wrong?

No gas Ridiculous...hoping that there is gas in your car...I would say either the starter or the ignition switch. When you get the car started, take it to autozone and let them do a free diagnostic on your alternator, battery, starter and ignition module.

Related questions

Have a 88 Chevy Celebrity engine will not restart after hot?

I would suspect a failing ignition control module.


What would cause a 1994 Mazda B-3000 to shut off while running?

I was told the computer was bad. I would test the computer first. It may also be the ignition module. I had the same problem with my '94 Mazda truck. It would be running fine and then just shut off. Also had trouble starting up every now and again. Usually i could just tap on the ignition module several times and it would start right up.


Where is ignition module on 2002 impala?

The ignition module on a 2002 Impala is located in part of the electrical system. In some cars, the module kept the car from starting. When the key was turned there would not be a clicking noise. The module works with the passlock system of the car.


Why would a Mazda MX6 manual transmission stall when put in gear?

Ignition module is bad I had a similar problem on a Pontiac grand am- it was the torque inverter. It would idle fine, run in nuetral, but as soon as it was put into gear it stalled with a thump.


What would cause a 2001 Silverado to start then instantly die?

ignition module


Your coil is good but truck won't start would it be the ignition modual?

more than likely is the ignition module. What year?


Would a body control module shut down a car while in driving motion?

Maybe the igniton control module or the ignition module are making bad contact.


What would stop your injector from firing on a 92 Chevy Suburban?

Ignition module in the distributor.


What would keep a 1998 2.2 Chevy truck from firing?

A bad ignition module.


Would a bad ignition module cause no fuel pressure in a 95 lesabre?

nope


How do you do you replace ignition module?

In a 83 Oldsmobile you remove the dist cap, unplug and unscrew the module and install a new module. It would be helpful to know if this is your lawnmower or boat engine.


Where can you find the ignition module in a 91 Volvo 740?

On my 90 740gl it is right next to the ignition coil. It depends on the ignition system used. On a Regina ignition, I think everything is built in the coil (The big square one) The regular round coil is for BOSCH ignition and a separate module is use. NOT SURE, would appreciate confirmation.