Hey, If all fuses are ok, then it must be the electronic flasher that located under the dash. Its look like a relay but little longer than relay and had 9 pins. The parts you can buy online (I bought it and paid 42 dollars including shipping). There is a part number written over it (if you take it out, you will see). I forgot something like 4*****. This flasher is not available any local store as I checked when I had the same problem. I searched on Google with the part number and found one website selling it and bought it from there, and received it within 3 days. The circuit diagram that I used later on (as puting that flasher still my signal didn't work only the emergency flasher was working.. so my previous flasher was ok as I had problem only with turn signals...(in your case you might be ok if you just change the flasher...if not..you can manually mutilate your turn signal function adding the following circuit that I had used to resolved the issue, instead of changing the whole BCM, which is expensive.)I am asuming you have enough electrical circuit knowledge although it requires the minimum knowledge to operate a volt meter to pick the right wire. If the circuit works, leave me an email as I will be happy to know that my knowledge helped you in some way. Thanks, AL-Amin [Note: as it was copied from note pad please copy it back to note pad to be able to view it correctly..thanks...If you still have problame email me at alaminsumon@gmail.com] +Right signal bulb(Test with a volt miter to make sure it is not the same bulb fillament which comes on when tail light/parking light switch is on) | |-L signal operate +Left signal bulb (you can draw these | | switch (follow the 2 wires under your carpet to the rear | |car repair manual 2 signal bulb case) | |get the right wire) | | | | - R signal oper | | | |ate swithch on Relay#2 pin#87 Relay#1 pin#87 | |Steering column | | |______________________________| | | | R#2 p# 86 R#2 p#85 R#1 P#85 R#1 p#86 | |---| |-| | |________________________________ R#1 P#30 R#1 P# 30 | | | | | | |_________________| | | | | | | ___________________________| | | | V AnyPIN AnyPIN +12V const of Thermal Battery Flasher Power to will be ok operate Relays
The 1987 Plymouth Voyager weighs in at about 3,305 pounds. The 1987 Plymouth Grand Voyager weighs right around 3,531 pounds.
A Plymouth Voyager does not have a maf sensor.
A 1996 Plymouth Voyager does not have a cabin filter.
The 1987 Plymouth Voyager weighs in at about 3,305 pounds. The 1987 Plymouth Grand Voyager weighs right around 3,531 pounds.
I have the same problem,left turn signal is dead,right one works and flashers work.I tested the switch its good,there is a modual under the dash that my be the trouble.Mine is a 96 voyager Steven344@yahoo.com I fixed mine there is a relay for the turn signals under the dash plugged in to the fuse box,its for the turn signals,take it out and pop the top off and re-solder the circuit board,that should fix it. Steven344@yahoo.com 12/07/2007
Where is the water pump located on a 1996 Plymouth Voyager?
how i install a R4736 relay in a 199 Plymouth voyager
code 41 -1993 Plymouth voyager - Alternator Circuit
what is the firing order for a 1999 plymouth voyager 3.3l engine
what is the firing order of a Plymouth voyager 3.3
belt assembly for a 95 Plymouth voyager
It doesn't, a 1996 Plymouth Voyager does not have a cabin filter.