Why would you keep blowing out ignition modules in a Chevy R-10 pickup?

[Edit]

Answer

I know a T-10 chevy pick upis 4-wheel drive and S-10 is a 2 wheel drive, what is a R-10 pick up?

Modules can go bad from old. worn plugs or wires, how old are yours?

Autozone modules and economy modules are also known for not lasting.

Answer

It could be that the modual is overheating due to engine compartment temp around that area. Double check replacement instructions and make sure you use dielectric grease between the mod. and mount area

Answer

My 94 C1500 has been doing the same. I replaced the module with one from Autozone along with the coil. The module went bad again four months later (7000 miles) and had it replaced by a mechanic. He said it went bad again because I didn't change the coil cable. Now just two months later, it has gone bad again (I think). I have had the plugs and plug wires replaced and it starts now and then. I'm going to replace the module with a better quality one but would also like to replace the two conductor wiring assembly that connects the module to the coil. It starts when I fool with the connector near the ignition module connector. Does anyone know where to find this wiring harness?

Improve Answer Discuss the question "Why would you keep blowing out ignition modules in a Chevy R-10 pickup?" Watch Question

First answer by anonymous. Last edit by ID3520506016. Question popularity: 102 [recommend question]

Research your answer:

Answers.com > Wiki Answers > Categories > Cars and Vehicles > American Cars > Chevrolet > Chevy Trucks and SUVs > Why would you keep blowing out ignition modules in a Chevy R-10 pickup?