answersLogoWhite

0


Best Answer

It could very well be an alternator/battery/charging system issue, bit it could be other things as well. Start by checking the conditions of your battery cables, the wiring running from the positive battery cable to the starter (make sure it is tight at both ends and in good condition) Check the primary out put wire from the alternator to the starter and make sure it doesn't show signs of overhearting. The wire is the large red or orange wire coming from a single terminal on the back of the alternator. Other causes could be a loose or defective connector on the back of the instrument cluster. Check the connectors and grounds to make sure they are in good condition, clean and tight. The problem could be the instrument panel itself. If it is, when you replace it your will have to do a learn procedure before the engine will start. To do this, you need to turn the key to the run postition and let the car sit until the "Anti-theft" light on the instrument panel stops blinking. Then turn the key off and the engine should start on the next try. This is all part of the Anti-theft system on you car and it involves the PCM (computer), Instrument Cluster, and the ignition switch. Good Luck if its a grand am gt with the "2.4 twin cam" then check the wire from the batt to the starter and from the alt to the starter i have a 2.4 and the guages went crazy because the wire from the starter to the battery was loose on the starter it also killed the battery because the alternator wire is connected to it at the starter if that makes sense -captain I had the same problem and it was the wire. I thought I tightened everything, and I had no problems for month. Now it's back. How can I keep everything tight back there? In addition to losing my gauges, I also lose my HVAC and power windows when the connection is interrupted. it sounds like you need to replace your instrument cluster. i actually replaced mine today my next problem is resetting the computer so the car will start have fun Your Alternator belt could be bad, I had the same problem. I just had to replace the alternator in my 96 Grand Am...and it did exactly what you described to a T. Good luck! My suggestion: go to a wrecking yard for the alternator (a yard that warranties parts like those) and then have a friend or someone who knows what they're doing change it for you. Otherwise, it will cost you an arm and a leg.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why would your instrument panel in a '96 Grand Am go nuts with no speed gas temp or rpm gauge?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What does it mean when the instrument panel not working?

possibly, the speed sensor


Why won't your speedometer and RPM gauge work in your 1993 Chevy Lumina?

The 1991 > 1994 Chevy Lumina Speedometer, Odometer and maybe the RPM gauge gets a signal from the ECM computer. This ECM signal is feed to a module in the instrument panel, which feeds the three items above. If all three are not working replace the instrument panel or the module (which is inside the panel), but swap the odometer to keep your mileage correct for the vehicle. Note: The ECM gets its signal from a VSS on the Transmission and the ECM feed three areas in the car: Speed Control, Speedometer and one other (?). If the speed control works, the problem is not the VSS or the ECM. The problem is in the Instrument Panel.


Why does your Silverado instrument panel sometimes fail?

These trucks are notorious for this issue. It could be a couple different things. The ignition switch is made of plastic and tendes to burn or short some of the contacts on it and will cause the instrument panel to shut off completly. The instrument panel itself could have a short it the circuitry somewhere and is actually quite common. It could all start from the gas gauge and oil pressure gauge failure, to inaccurate speed or rpm readings to total failure. Id start with ignition switch first being that its the cheapest to fix then go from there. good luck!


Where is the speed sensor buffer for a 1989 Chevy 1500 pickup?

It is a part of the connector from the speed sen sor to the dash instrument panel. The manual says it is behind the glove box


Which fuse controls the speedometer on C220 Mercedes?

# 11....it controls the instrument panel....speedometer could be a seperste issue involving the speed sensor in the differential.


The instrument used to measure wind speed is a?

No. The instrument used to measure wind speed is an anemometer.


Where is turn signal flasher on a 1998 Olds delta 88?

Under the instrument panel on left side. There is a hush panel. (Plastic cover with three screws and a speed nut). Remove panel, flasher is fastened on top of fuse box under this panel. Difficult scale, 1 to 10 it's a 1 (one).


Will the instrument cluster out of a 91 to 98 fit and function in your 89 1500?

NO it is not anywhere close to the same. This is not exactly true. 91 was a cross over year. It was the first year for the new style gauge panel with the tach but the last year for that style wiring and speed-o-meter control box. So if you have a pre 92 truck and want the newer style gauge with the tack there is only one year pickup that is a direct bolt in.


How is the speed of an aircraft measured?

the speed is measured by using primary flight instrument...this instrument have air speed indicator by which v cn measure d speed of airplane..


How many miles can you drive with a full tank in a 2001 grand am se?

that changes depending on your driving style, the terrain, your speed, the condition of the engine, and other factors. it is hard to gauge


What instrument is used for speed?

radar


What is an anamometer?

It is an instrument that measurwa 'Wind Speed'.