yes but you need to modified. this is for a complete body swap. prior to install tacoma cab on 89-94 frame you must une a 3in body lift to clear gaz tank because the tank are other side of tacoma, the rear body mount fit direct the second in the front of door must be slotted 1\2 in per side. and for the front under the radiator you must drill 2 new holes really easy. the stering colum must be removed and use older shortened rod. for the bed ,tacoma use 6 bolt and older 8. you must extend 2in rear frame and make a plate 11in x 3in and bolt them to the frame dril an hole in center. now the last thing is the fuel door is o the wrong side me i prefer make a long tube to fill the tanks by the other side or you can sheve them and reintall them on the left.
Does a toyota 4 runner have the same frame as a toyota tacoma
No, different frame.
You tried eBay? They're good, there are many other sites that you can buy used cars of though.
It is located under the vehicle, passenger side, below bed, rear frame rail, mounted in fuel line.
location is under the frame, you need to check on your local DMV to see if they match with the visible numbers (dash and doors)
there are tons of people with this problem that got a lot of money from Toyota for this problem. Its called tacoma buyback program. look into it, i got 11,100 $ for a truck i pai 5500$ for.
Its on the inside of the frame of the truck between the cabin and the bed. it is not on the inside of the frame of the truck between the cab and the bed. it is under the intake manifold on the drivers side of the block.
How can you bend the frame without cosmetic damage? Did you run over something? Depending on your insurance coverages, if a vehicle has a bent frame and is no longer safe to drive, then an insurance compamy would usually total out a vehicle. Otherwise, they can pay to repair the vehicle.
It is located under vehicle, passenger side, below bed area, passenger side rear frame rail, mounted in fuel line.
Most all fuel filters now regardless of make are located on the drivers frame rail underneath the car midpoint between the tank and the engine. ..1930fcoupe
Passanger side rear along the frame.
should be attached to the frame driver side. crawl under and look at the lines attached to the frame follow it till you come to the filter.