Valve grind will affect compression, but not engine smoking. If the valve stem seals were not replaced you may get some oil burning, but that's not something that most shops will miss.
Oil burning is typically caused by:
* poor ring seal against the cylinder walls (rings that ran without adequate lubrication, inadequate maintenance resulted in sludge buildup in the ring groove, cylinder wear that prevents ring seal) * cylinder wash-down (too much raw fuel getting dumped into the cylinder, mixing with the oil on the cylinder wall then it all burns.) * cracked piston In general, it's always a good idea to rebuild the entire engine when you tear down for a valve job. An engine seldom wears out in just one part.
1973 350 Corvette. 76cc chambers. 2.02`` intake valves 1.6`` exhaust valves.
1973 Chevy pu wireing diagram
Chevy Van - song - was created in 1973.
Yes.
a 1973 Chevy truck has HEI Answer And if it does have points, say not the original engine, its .018-.019 will do.
Clockwise
Yes.
no it wont just bolt on....
No a 1972 Chevy pickup is not the same model as a 1973 Chevy pickup. I believe it goes from 1967-1972, 1973-1980, 1981-1987. Doors will work from 1973-1976, 1977-1987. You would need to find 1972 doors as they are the only ones taht will fit a 1972. 1967-1971 are the same but there is something different about 1972 doors.
If it is the same bodystyle, yes
No, completely different body style.
A voltage regulator on a Chevy 1973 or newer is built into the alternator.