Want this question answered?
No, 120 v is not enough.
The internal working of the motor is designed for 110V/60Hz. Your stepdown converter is from 220V/50Hz to 110V/50Hz. Frequency converters from 50Hz to 60Hz are very expensive (many times the cost of a new clipper). Therefore it is better you get a clipper designed for 220V/50Hz. If you still like to put your clipper to use, then the most cost effective solution would be to get a "car inverter" that would convert 12V DC to 110V/60Hz AC.
The US does not use 120 volts at 50 Hertz.
No. For more information see the answers to the Related Questions shown below.
No India uses 240V at 50Hz the U.S. uses 110V at 60Hz.
Depends. Some smaller stuff can usually run on both, in which case it will be printed on them. If it isn't, you can't run a 220v item on 110v.
Do you mean definition? If so 110V = 110 volts-60hz = 60 hertz. Hertz is the cycles that the electricity runs at. 60hz. is the US standard. Europe is at 50hz.
You can get a transformer that converts the UK's 230V power to 120V, but you cannot get a transformer that will convert from 50Hz to 60Hz. Often, US equipment can work, except that they will work hotter and less efficiently on the 50Hz power. Consult your clipper and trimmer documentation - you may find that it will work just fine on 50Hz.
The answer to your question varies on what the tool requires. In some European countries, they run 110v @ 50Hz as well as supply 220v @ 50Hz. Check your tool's power information to see if it runs on dual voltage. I know that most of my tools that I have bought from the United States require 110v @ 60Hz but operate just fine in Europe. The short answer is, probably yes, but check with the manufacture's user guide.
NO dear we can not rotate a 110 vlolt motor on 220,but if your voltage is 110v then y can rotate it on 50hz ,no problem,but it will rotate at lower speed, ENGR. NASEER AHMED,PAKISTAN
Depending on the device, it may or may not work. And if it works, it won't work properly. A 60Hz devices needs 60 cycle current, not 50.
If the load is non inductive and straight resistive then there is no problem. Inductive loads like motors, a 60 Hz device can be used on 50 Hz but it is much harder on the equipment if 50 Hz is used on a 60 Hz system.