350 TBI uses an in tank pump to provide about 13 - 15 lbs pressure at the TBI unit. Pour some gas down the throat of the TBI and see if it starts - while it runs for a few seconds, check to see if any amount of fuel spray is coming from the 2 injectors inside the top of the TBI. I had this same problem, but it was the alternator wire from battery to alternator had burn thru, had to repair (solder and Tape) until I could replace this wire. It worked for me. If this working, there will be a continuous fine spray in a cone shape. If not, since the fuel filter has been replaced, you likely have an intank pump that has quit or almost quit. Check that the fuses, wiring etc are OK back to the pump. Next step - remove the tank and remove the pump. You can check it on the bench to see if it will turn over but likely it is toast.
There are a few different reasons for oil loss in a 2003 Suburban. This could be because the oil filter needs to be replaced or the oil drain plug needs to be replaced.
The fuel filter on a 2006 Suburban is in the fuel tank. Chevy started putting the filter in the tank in 2005.
How do you change the oil filter sending unit of a 1999 suburban?
NO.
The 2003 Chevrolet Suburban fuel filter is located inside of the gas tank. You will to remove the gas tank in order to change the fuel filter.
You need to check the up stream or dirty side of the intake system
Filter installed in reverse.
It was not used on that year.
It doesn't have one
frame rail
No it does not.
A quality filter such as AC/Delco is the filter your should use.