mine is not working any more
The tube allows condensation to leave the battery. It simply leads down towards the bottom of the bike so that the condensation doesn't drip onto the bike.
The function of battery terminals is to connect a load or charger to a cell battery. Battery terminals are necessary and common in a lot of batteries.
It's not battery acid, it's mostly condensation, just have it dripping towards the ground. Good Luck!!!
The primary function of a battery grip is to increase battery capacity and also to be used as another handle for the camera to be used as an extra grip for the photographer.
The primary function of a battery grip is to increase battery capacity and also to be used as another handle for the camera to be used as an extra grip for the photographer.
to check how much electrolyte is present in the battery
Its not known
Clean the top of the battery to avoid electrical discharge from condensation. Charge the battery once/month. Store it away from water heaters and furnace. Rick
the function of a battry is to give somthing power without wires
A car battery's function is to store electrical energy for your vehicle. When you start the car the stored energy in the battery turns your car over and once your car starts the alternater will power everything and recharge the battery.
Unscrew the battery connectors, unhook the condensation tube, lift the battery out of the holder. Put the new battery into the holder and reconnect everything. It is always a good idea to disconnect the negative battery connection first and replace it last to prevent accidental shorting.
A slot on the motherboard intended to hold the CMOS battery.