It means there is a problem with the Anti-Lock Brake System. Check the fluid level in the Master cylinder. If the fluid level is ok, then take it to a professional for repair. you can also reset it by turning over and on the ingintion swith three times
2003
My son had the same problem on his 1995 Monte Carlo. The brake light in rear window worked , as did the tail lights and emergency flasher but no brake lights came on when pushing the brake pedal. Anyway , the problem was in the turn signal switch. This involved taking the steering wheel and column apart , taking the airbag out ( careully ) and it was more than I wanted to handle. The mechanic charged 227.00 including part and labor. .
'signs' came out with her dangerously in love album, which came out on June 24th, 2003.
It came out in 2003.
The release date of Dangerously in Love by Beyonce was June 24, 2003!
check brake light switch under pedal . It might have came loose from bracket
You might be out of brake fluid. Our rear wheel cylinder was leaking and ran ours out of fluid and the light came on.
By following the instructions that came in the box of the new trailer brake controller.
I know on my durango...I went away for a week and when I came back my abs and brake light came on and stayed on. It ended up being one of the sensors on the brake went bad. I hope maybe this will be useful.
Check the brake fluid...
On your 2003 Mercury Mountaineer : A problem has been detected with the Anti-lock Brake System It could be a fuse , a sensor , or some other problem As long as the red " BRAKE " light is not on in your dash , you still have " normal " brakes * my ABS light suddenly came on and the first ABS fuse I checked was not installed all the way (I don't know how that could have happened ! ) I touched the fuse with my finger , heard a " click " and the ABS light went out ( just lucky I guess , but suspicious )
center brake lites came out on 1994 4runners
You probably need to change your back brakes.
Probably a brake light switch problem. May be able to adjust, or may need to replace. I just replaced the brake light switch in my 1998 Mazda Protege LX and the problem came back. I believe the cruise control could be shorting out the brake light switch.
the abs plug in on the wheel came off or it is a higher possibility that the brake fluid is low and when it gets to the limit line the light comes on
The ABS computer has detected a malfuction and set a code.
It's probably your Alternator that is going bad. That is if the battery and brake lights came on at the same time.