answersLogoWhite

0

Can you just spray the maf or do you have to handle it?

Updated: 8/18/2019
User Avatar

Wiki User

14y ago

Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Can you just spray the maf or do you have to handle it?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can MAF Sensor be cleaned?

Yes. Most parts stores carry MAF Cleaner in a spray can. If your MAF is grimey, it can cause your engine to run rough, hesitate, etc... MAF Cleaner will help a lot. Just be careful handling the MAF, it's a delicate part.


How do you clean an MAF sensor on a 2001 escort zx2?

I'm trying to figure that out myself. I do know you need a can of maf cleaner, about $7. You have to be careful not to damage the maf or a new one is $125. Spray a few inches away, I would think. Like I said, trying to find out myself.


How can you eliminate idle hesitation on a 1986 BMW 535i?

Hesitation fixRemove air inlet hose from air filter housing to MAF sensor. Spray carb cleaner into MAF sensor (with car off) and work flap slowly and wipe inside of MAF sensor with lint free cloth. Also check hose at MAF sensor for cracks.


Where is maf sensor on 2000 Celica gt?

Spray it with Brake Cleaner and wipe it with a Q-Tip. Then blow it dry with air.


How do I uses Toilette spray?

First you put the nozzle were you want to spray and then push the handle down.


Can maf sensor cause P0171 P0301?

Yes, the maf sensor can cause 0171 code, (lean condition). I had that code and my 2000 echo acted like not getting enough fuel. I already replaced an oxygen sensor which was no help. In response to a tip on this site that echo is prone to show this code due to dirty maf,, I cleaned the maf with electronics cleaner spray and dried it with compressed air. I erased the code, trouble light stays off and performance improved dramatically. The maf did not look very dirty but apparently a little dirt is a lot on an maf. It is expensive and fragile so only use electronics spray and compressed air. Don't directly touch the sensor wires.


What does code P0172 system too rich bank 1 mean?

Your vehicle is either getting too much air or gas. I would buy some MAF cleaner and spray your MAF sensor and see if that takes care of it.


Where is location of maf sensor on a 2002 ford escape?

The MAF sensor is just behind the air filter on your air intake


How do you clean maf sensor Mitsubishi carisma gdi?

You really shouldn't. It is part of the entire engine control system and cleaning it would probably damage it. If you insist on cleaning it, take it off the vehicle and just spray it with Electronics cleaner that HAS NO LUBRICANTS!!


What does the trouble code po171 mean for 2000 Chevy Malibu?

po171-- system to lean ( bank one ).-this could be a vacuum leak, fuel pressure could also cause a problem. if a leaking vacuum hose you will hear a hissing sound from engine compartment. most of the problems can be corrected by just cleaning the maf sensor. you can buy a can of maf sensor spray at any auto parts store and just follow directions on can. on v6/v8/and v10 bank 1 is the bank that the # 1 plug is at. good luck!! i cleaned my maf sensor and it helped alot.


Where is maf sensor located?

in the hose just behind the air filter


What causes 2000 Malibu engine surge?

mass air flow sensor.(maf) this is the sensor for air entering engine, it is just before throttle body in hose from air cleaner. make sure air filter is clean, remove hose to get at sensor.take sensor off of vehicle, be careful not to touch the fine wires in side of it. put on a clean cloth and spray element with maf sensor spray. you can buy the spray at any auto parts store. becarefull not to touch sensor with anything, cause they cost a lot to change. by cleaning sensor you can improve mileage, a better idle, and controls surgeing. I did this to my 3.1, and it helped a lot.