answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Does a 95 mercury mystique have a thermostat gasket?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is a 95 Mercury Mystique 2.0L a contact motor?

No , the 2.0 liter is not an interference engine in the 1995 Mercury Mystique


How do you tell if your 95 Mercury Mystique has abs?

ABS came as standard equipment on the 95. It has ABS.


How do you get a wiring schematic for a 95 mercury mystique?

you can get free on line at autozone.com


Why is my 95 Monte Carlo leaking water from behind the thermostat?

thermostat gasket probably leaking. replace thermostat and gasket making sure that thermostat housing is flat.


Where is the starter relay on a 95 mercury mystique?

Follow the + battery cable should connect to relay


Does the 95 mercury mystique come standard with airbags?

Yes,it had dual front airbags as standard on all trim levels.


What size wrench do you use the replace egr vale from pipe on a 95 mercury mystique v6?

inch wide adjustable wrench


Head bolt torque 97 mercury mystique spree 2.0?

you need to get them down at 95 ft pounds every other


Where is the oxygen sensor on a '95 Mercury mystique?

Mercury Mystique with V6 engine has two oxygen sensors. First one located between radiator and engine, second - behind the engine, near the coil pack (below). It's not very difficult to replace them.


Will the thermostat on a 95 Chevy S10 Blazer leak if missing outside gasket?

They don't use an outside gasket. It has a rubber ring around the stat that makes the seal.


Where is and how do you change a speed sensor on a mercury mystique mfg June 5 1995?

We just changed one on a 1995 Mercury Mystique 4/95. It was located on the transmittion. They tell us there are 2 for this model, other one is supposed to be located in Instrument panel but we couldn't find it.


How do you change a Thermostat on a 95 eagle vision?

To change the thermostat-- * drain the cooling system down to thermostat level (or lower) * remove the two (2) thermostat housing bolts, and the housing itself * remove old thermostat, discard gasket and clean both gasket sealing surfaces (pay attention to the orientation of the thermostat when you took it out; it only works one way) * install the new thermostat * place new gasket onto water box surface, over the thermostat, and center the thermostat in the opening of the intake manifold * apply gasket sealant, if necessary * place the housing over the gasket and thermostat, and torque bolts down to 250 in. lbs. * refill cooling system to compensate for lost coolant