How do you use another persons urine to pass a drug test?

Answer 1

Have them pee in a bottle within 48 hrs of the test. 10 hrs before the test put the bottle in a pot of warm water to get it near body temp. Fill a unlubricated condom with the urine and tuck it under your "stuff" in some briefs for like 4hrs before test to ensure body temp. Get a safety pin and put it on the inside of your fly. Be ready to possibly get dirty.... Or inject clean urine directly into your bladder.

Answer 2

If you mean how this is possible, many people break the law by collecting a urine sample from someone who doesn't do drugs then use that urine instead of their own for a drug test in order to stay out of trouble.

Answer 3

# This is extremely difficult to do, as dye is placed in all the toilets, and someone goes in with you (outside of the stall) to monitor that all is above board. The temperature of the urine is measured too.

Answer 4

Um have your friend give you the urine the fresher the better so try to get it the same day as the test if you can and smuggle it in with a condom or something the only problem is it has to be 90 degrees so you have to heat it before you use it also make sure you use the same genders urine

Answer 5

yes it is. as ling as the urine is less than 24 hours old it should be fine. the key here is to make sure they don't check temperature. if they are gonna test temp, just buy a hand warmer and keep it wrapped around whatever your storing the urine in. it works with synthetic urine (find at a headshop) as well.

Answer 6

I recently passed a urine test at a screening lab (unsupervised) with this method:

• Find a container to hold clean urine. I used an empty UPass container that I had because it has the temperature reader on the side which makes it less of a guessing game.
• Wash out container thoroughly and get a friend to pee in it.
• Immediately after that go to wherever the test will take place. Make sure you don't waste time because urine can start to get bacteria which will make your test an automatic fail. In my case it took about an hour to get to the place and be called back to test and it worked fine.
• On the way there I kept the car heater on full blast hot air and held the container of urine on the vent so it stayed hot.
• When I arrived at the testing site I put the container in my underwear tucked securely in my (for lack of better words) gooch with a hand warmer up against the side of the container to keep it hot. The urine sample has to be between 90° and 100°F to pass (it should be if you follow these steps).
• When you go into the bathroom you should pee a little bit into the toilet so they don't think you're faking it and then pour the clean urine into the sample cup and that's it.

Good luck!

Answer 7

That's a well known trick. If it's for probation, they stand there and watch you to make sure you don't use someone else's urine.