flip flop:
-> it work's on the basis of clock pulses.
-> it is a edge trigerred , it mean that the output and the next state input changes when there is a change in clock pulse whether it may a +ve or -ve clock pulse.
latch;
-> it is based on enable function input
-> it is a level trigerred , it mean that the output of present state and input of the next state depends on the level that is binary input 1 or 0.
Both the flip-flop and latch are Sequential circuits....
latch has enable signal and is level triggered,while flip flop has clock signal &is edge triggered and it uses latch in its circuit.
bokum
Latch A latch remembers the last state it was told to with another latchingsignal Buffer A buffer merely strengthens a signal so that it canbe fanned out with integrity or drive a heftier device. Any amplifieris a buffer. It outputs a state only as long as the state persistson its input(s).
One difference between an SC and an LC connector is that an LC connecter is smaller in size than an SC connector. Also, an LC connector is considered a latch connector, whereas an SC connector is considered to be a push-pull connector.
A: it does not apply to only flip-flop but to all kinds of logic circuits where a [+] transition from a less negative to a more positive level occurs [-] and the other way around meaning a +/- transition must occurs to transfer states.
They are sandals that have a piece of plastic or cloth that goes between your toes. They are also called, though not by me, foot thongs, for that very same in between the toes thing. In New Zealand they are called Jandals ( short for Japanese sandals).
FF-sincron L-asincron level sensitive and edge sensitive
Because that is the definition of a latch. A J-K flipflop is master-slave triggered because that is the definition of a J-K flipflop. A D flipflop is edge triggered because that is the definition of a D flipflop.
flipflop is edge triggering and latch is level triggering
Generally speaking, a latch is a device that will respond to an input level (logic high or low) whereas a flip-flop will only respond to its inputs when the proper triggering edge (transition between logic levels) is applied. Be cautious as some people use the terms interchangeably.
static latch: a latch without capacitor dynamic latch: latch with capacitor
bokum
The difference between a latch and a flip-flop is that a latch does not have a clock signal, whereas a flip-flop always does. Apart from the clock signal difference, ~ Latch is a level sensitive device while flip-flop is an edge sensitive device. ~ Latch is sensitive to glitches on enable pin, whereas flip-flop is immune to glitches. ~ Latches take less gates (also less power) to implement than flip-flops. ~ Latches are faster than flip-flops.
From the excitation table of D flipflop , clear that D flipflop act as a buffer. It also used to make shift registers.
tie both J & K high.
toggle flipflop - every clock pulse toggles it to the opposite state.
Yes, "flipflop" is a compound word formed by combining "flip" and "flop."
No they don't rhyme.