* It depends on what is on that circuit. Lamps and clocks and ordinary household items should be fine, but computers and expensive electronic devices like TV's and stereos don't like this sort of behavior. * Each "cycling" of any electrical switching device results in some wear. Therefore, the use of a circuit breaker like a light switch IS NOT RECOMMENDED. At some point, the accumulation of wear can result in eventual failure of the breaker.
nope it should'nt but you should have a surge protector in line with any electronics of any value
No, it will not harm the stove.
Circuit breaker or switch
That sounds like an overload condition, meaning that something on the circuit is drawing too much current and the breaker responds by shutting off.
Some breakers can trip totally off. If the breaker is continually turning off without a wiring issue, then the breaker could be going bad.
Turning the breaker on allows the power to flow through to the outlets, lights, and appliances on that circuit, so yes power goes to and through a turned on breaker. If the breaker is off, but the main power is on, power still get to the breaker, usually from the bus bar that runs down the middle of the back of the breaker box.
No, it will not harm the stove.
Circuit breaker or switch
That sounds like an overload condition, meaning that something on the circuit is drawing too much current and the breaker responds by shutting off.
By unplugging the device in question or turning off the breaker for the fixture in question.
no so...... knock yourself out
Manually turning off a shunt trip breaker should not set off the fire alarm. The only way that the breaker could set off the fire alarm when turned to the off position is if there is an auxiliary contact on the breaker connected to the fire alarm circuit. This is not usually done because the breaker should be able to be turned off when doing maintenance on the breakers circuit. If the breaker is a mandatory feed breaker to a piece of fire alarm equipment and shouldn't be left in the off position it might have a trouble circuit connected to the fire alarm panel. A trouble alarm on a fire alarm panel is different from an alarm circuit alarm.
You need to turn off the power at the circuit breaker.
Some breakers can trip totally off. If the breaker is continually turning off without a wiring issue, then the breaker could be going bad.
No. Power to all the circuit breakers will be cut off except for the Main power breaker. The Main power breaker (which supplies power to all other breakers and will say 100, or whatever your max breaker box power is, on it )will have power going to it all the time, unless power is turned off outside the house.
A circuit breaker does not give off amperage. A circuit breaker allows a flow of current up to the rating of the breaker. Any current higher than that of the breaker's rating will open the breaker's contacts and stop the flow of current.
Turning the breaker on allows the power to flow through to the outlets, lights, and appliances on that circuit, so yes power goes to and through a turned on breaker. If the breaker is off, but the main power is on, power still get to the breaker, usually from the bus bar that runs down the middle of the back of the breaker box.
Yes, but I would not recommend it if you are constantly turning the power on/off. If that is the case install a disconnect.